Application Guide

Aica Aibon, Polish Type Applicaton Guide

Aica Aibon, Spray Type Applicaton Guide

1 Surface to be bonded must be clean and dry.
2 Surface treatment :
eliminate oil rust and other stain from the surface of the material to be bonded before degreasing it by using solvent.
3 Spread method :
Use the spray gun with an aperture of approximately 2,0 mm, the air pressure set to 3-5 kg/ cm2 , and any moisture eliminated from the compressed air. Spraying distance is 30–60 cm, that the bonding agent is spreader uniformly to both sides of the bonding material.
4 Apply Aica Aibon spraying but do not dilute it. Quantity spray for non porous media 120 ~ 150 g/m2 and for porous media 150 ~ 180 g/m2
5Adhere both sides using special roller or press (pressure weight 2~5 kg/cm2).

logowhite

Marketing Office

  Gedung Pakarti Centre 8th Floor, Jl. Tanah Abang III No.23,25,27. Jakarta Pusat 10160 - Indonesia

   +6221-38901941 / +6221-38901942
   +6221-38901943
   This email address is being protected from spambots. You need JavaScript enabled to view it.
    www.aica.co.id

Bekasi Factory (Head Office)

Jl. Ir. H. Juanda No.318, Bekasi 17113 - Indonesia
+6221-8801391 (Hunting)
+6221-8802807

Cikampek Factory

Sector 1A Blok K-5B, Kawasan Industri Indotaisei
Kota Bukit Indah, Kalihurip, Cikampek Karawang 41373
Jawa Barat - Indonesia